Maintenace; General Maintenance; Replacing The Battery - koban KMD 06 Manual De Instrucciones

Multímetro digital
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery Test
Position
Resolution
12V
9V
1.5V
Overload protection: F400mA H 600V fuse.

Maintenace

General maintenance

This section provides basic information on maintaining the meter, such as
replacing fuses and the battery. Only experienced and authorized personnel
should make repairs to the meter.
Warning
To avoid injury or damage to the meter, do not allow moisture inside the
case and remove test leads before opening battery cover.
Use a damp cloth to regularly clean the aoutside of the meter. Do not use
abrasives or chemical solvents. Dirty or damp input jack can adversely affect
readings.
To clean input jacks, follow the following steps:
1. Turn off the instrument and remove test leads.
2. Clear any dirt or other particles on tje input jacks.
3. Use a cotton ball/swab with a lubricant (i.e. WD-40) to clean off the
contacts of the input jacks.
4. Use a separate cotton ball/swab for each jack to prevent cross-
contamination.

Replacing the battery

Warning
To avoid false readings and potential dangerous situations, replace te
battery immediately when the
Turn off the meter and disconnect the test leads before opening the
battery cover to prevent electrical shock or personal injury.
www.grupotemper.com
0.01V
±(0.8% of reading + 7 digits)
0.01V
±(0.8% of reading + 7 digits)
0.001V
±(3.0% of reading + 5 digits)
symbol appears.
KMD 06
Digital multimeter
Accuracy
Instructions manual |
25

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido