Analog Operation With A Switch - ABB Busch-Dimmer 6597-500 Manual De Instrucciones

Modes of operation
Cleaning light
This mode of operation is activated via an external
conventional switch (Fig. 1, Pos. 3); channels D1 and D2
are set to a brightness level. The brightness l
on the setting on the coding switch.
● Push pin 5 on the coding switch to "on" to
increased brightness level.
Analog operation with a switch
In order to separate switching/dimming from
in an og operation, the switch on pin 6 al
"o n".
T he condition for this mode of operation is that a switch
(e.g. a time switch) has been connected to pushbut
in ut T1, which then assumes the switching functi p
Other pushbutton and analog signals are
ignored.
ENG
evel depends
enable an
operator input
mu st be set to
ton
on.
38