ABB Busch-Jalousiecontrol II 6411 U-101-500 Manual De Instrucciones página 61

Programming
● Use a screwdriver to lift the control element off with the
frame once more.
● Exit the "Programming" mode of operation and reset
the originally desired mode of operation.
● Re-attach the operating element.
Programming can simplified, if an extension has
been installed and is used to program the
intermediate position.
● If programming has been correctly carried out and the
shutter is in the upper end position, the shutter moves
downwards for the programmed downward motion time
on receiving a move down command, pauses for 0.5 s
and then moves upwards again for the time
programmed for the return travel pulse.
● If the shutter is not in the upper end position, the move
down command is executed without the programmed
intermediate position. Shutter moves downwards for
three minutes.
ENG 61