BABYTREND TS86C Manual De Instrucciones página 4

ASSEMBLY
Remove stroller from box. The front wheel
and rear wheels be installed prior
MUST
to use.
FRONT WHEEL
To attach the front wheel, unfold stroller as
described in the section following:
1) • Unlock the release lever (Fig. 1a) and
unfold stroller frame by pulling upward on
the stroller handle until the frame locks
(Fig. 1b).
• Lean the stroller backwards so that the
front wheel post is pointing upward. Push
the front wheel assembly onto the front
wheel post until locked into place.
Skip to the next step if this part has
already been assembled (Fig. 1c).
NOTE: Pull on the wheel assembly to
ensure that it is securely attached to the
stroller.
REAR WHEELS
2) • Lean the stroller forward to rest on the
front wheels.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 2).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
use stroller if wheels do not
NOTE: NEVER
lock into place. If you need assistance,
please contact our customer service
department at 1-800-328-7363, Monday-
Friday, between 8:00 am and 4:30pm, PST.
5
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
MULTI-POSITION HANDLE
3) • To adjust the handle, press the release
buttons to move the handle up or down
to a comfortable position for the user
(Fig. 3).
NOTE: Make sure the handle clicks into
place before using.
BUMPER BAR
WARNING
Fig. 1a
bar is not designed to be used to as a carry handle or
support a car seat, stroller may become unstable.
WARNING:
hold the child in the seat. The child should be secured
in the seat at all times by the 5-point restraining
system.
4) • Attach the bumper bar by lining up
Fig. 1b
anchors with the slots on the seat. Push
until it clicks into place (Fig. 4a).
NOTE: The bumper bar must be
securely attached before using this
product.
• To detach bumper bar, press the release
button on the bottom of the bar and pull
bar out of the anchor. Swing the bar
Fig. 1c
upwards to access the seat (Fig. 4b).
Fig. 2
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
:
FALL HAZARD
Bumper
The bumper bar is not designed to
Release Button
Fig. 3
Fig. 4a
Fig. 4b
6