Sauder 412093 Manual Del Usuario página 11

Step 7
First, fi ll the holes in the short edges of the FRONT PANELS (G3 and H3)
å
1/4 to 1/2 full with GLUE (54M). Then, insert two WOOD DOWELS (15F)
into the holes. Wipe away the excess GLUE.
Fill the hole in the middle of the LOWER FRONT PANEL (H3) 1/4 to 1/2
å
with GLUE. Be sure to fi ll the hole closest to the unfi nished edge.
Now, fi ll the holes in the RIGHT END (E3) 1/4 to 1/2 full with GLUE. Be sure
å
to fi ll the second and fourth holes from the rounded edge as shown.
Fasten the FRONT PANELS (G3 and H3) to the RIGHT END (E3) and
å
UPRIGHT (C3). Tighten four HIDDEN CAMS.
NOTE: Be sure the WOOD DOWELS in the FRONT PANELS insert into the
å
holes in the RIGHT END and the WOOD DOWEL in the UPRIGHT inserts
into the LOWER FRONT PANEL. Wipe away the excess glue.
Lastly, fi ll the holes in the opposite short edges of the FRONT
å
PANELS (G3 and H3) 1/4 to 1/2 full with GLUE. Then, insert
two WOOD DOWELS (15F) into these holes. Wipe
away the excess GLUE.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
15F
www.sauder.com/services
C3
Finished edge
M S
C A
E N
I D D
u t H
i t h o
e w
f a c
M S
S u r
C A
E N
I D D
u t H
i t h o
e w
Unfi nished edge
f a c
S u r
Fill the holes 1/4 to 1/2 full with GLUE.
Rounded edge
E3
G3
H3
Maximum
210 degrees
Minimum
190 degrees
412093
54M
R i g
h t E
n d
15F
Arrow
Page 11