Hidden Cam; Black 1-9/16" Flat Head Screw - Sauder 412093 Manual Del Usuario

Step 11
1
T
D212
å Pull the DRAWER FRONT BRACKETS (8G) apart and slide them
into the grooves in the DRAWER SIDES (D212 and D213). You may
need to gently tap them in with a hammer.
å NOTE: The DRAWER FRONT BRACKETS are marked "RH" and
"LH" for easy identifi cation.
å Fasten the LEFT DRAWER FRONT (T) to the DRAWER FRONT
BRACKETS (8G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
3
M65
Surface with

HIDDEN CAM

Fasten the DRAWER BRACE (M65) to the DRAWER
å
FRONT (T). Tighten one HIDDEN CAM.
www.sauder.com/services
D213
Push down
8G
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
Maximum
210 degrees
Minimum
190 degrees
T
2
D212
1S
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (B30) into the
å
grooves in the DRAWER SIDES (D212 and D213)
and DRAWER FRONT (T).
4
Arrow
D212
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the DRAWER BACK (D476) to the DRAWER
å
SIDES (D212 and D213) and DRAWER BRACE (M65).
Use fi ve BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the other drawer.
412093
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
B30
U n fi
n i s h
e d
s u r
f a c
e
T
Start each screw a few turns before
completely tightening any of them.
30S

BLACK 1-9/16" FLAT HEAD SCREW

(10 used in this step)
D476
M65
D213
D213
Page 15