Power Connection - Philips AJ 3940 Manual Del Usario

CONTROLS
TOP, FRONTSIDE and BACK PANEL
1 SLUMBER - to adjust the slumber time
2 /REPEAT ALARM
DAY
– to switch off the alarm for a 9 minute
period
– to set the day for weekend sleeper
activation
3 24 HR RESET - to stop the active alarm for
24 hours
4 PUSH•OPEN - to open/close the CD door
5 TRACK SELECT - to select/review TRACK
SELECT number for ALM 1 or 2
6 DISPLAY - to show the clock/alarm times
and status of the set
7 PLAY 2 - to start CD playback
8 9 OFF
– to stop CD/Radio/Slumber function
– to cancel the TRACK SELECT setting
– to cancel alarm setting(s)
9 DBB - for an enhanced dynamic bass boost
0 ALM 2 - to set/review/switch off ALM 2
! BRIGHTNESS - to change the brightness of
the display illumination
@ ALM 1 - to set/review/switch off ALM 1

POWER CONNECTION

1. Check if the power supply as shown on the type plate (on the
bottom of the set) corresponds to your local power supply. If it
does not, consult your dealer or service center.
™ If your set is equipped with a voltage selector, found on the
bottom right-hand corner of the set, adjust the selector to
correspond with your local power.
2. Connect the power plug to the wall socket.
– The power supply is now switched on and the numbers on
the display will start to flash. You will need to set the
correct time.
3. To switch off the power supply completely, pull the power plug
out of the wall outlet.
# ∞ / §
– to adjust clock/alarm times;
– to set the day
– to skip CD tracks/search for a particular
passage
– to set a CD track for ALM 1 or ALM 2 in
TRACK SELECT mode
– to select the buzzer melody for ALM 1 or
ALM 2
$ WEEKEND SLEEPER - to deactivate ALM1
or ALM 2 for the weekend
% TIME - to set the clock time
^ BUZZER - to select the buzzer mode for
ALM 1 or 2 - to select the buzzer melody
& RADIO ON
– to switch on the radio
– to select radio mode for ALM 1 or ALM 2
* BAND - to select FM/AM waveband
( p - 3.5 mm socket for plugging in
headphones/active speakers
) VOLUME - to adjust the sound level
¡ TUNING - to tune to radio stations
™ Battery door - for backup batteries
£ Pigtail antenna - antenna to improve FM
reception
≤ Power cord - for AC power supply
INSTALLATION
7