Radio Reception; Setting The Alarm Time - Philips AJ 3940 Manual Del Usario

RADIO

RADIO RECEPTION

1. Press RADIO to switch on the radio mode.
ON
™ The RADIO indicator
2. Adjust the BAND switch to select the waveband.
3. Use the TUNING control to find your station.
To improve radio reception
FM: extend the pigtail wire at the back of the set
completely for optimum reception.
AM: uses a built-in aerial. Direct the aerial by adjusting the
position of the set.
4. Adjust the sound using the VOLUME and DBB controls.
5. Press 9 OFF to switch off the radio.
™ The RADIO indicator disappears from the display and the
radio is switched off.

SETTING THE ALARM TIME

General
Two different alarm times ALM 1 or ALM 2 can be set in a
variety of modes. This can be useful when for example you need
to be woken up at a different time during the week or at the
weekend.
Note: The ALM 1 or 2 button should be held down throughout
steps 1-4 below.
SETTING ALARM 1 or 2
1. Press and hold down the ALM 1 or 2 button.
™ day appears in the display if you have not set the day
(see SETTING THE DAY)
2. Press ∞ or § to set and adjust both the hours and minutes:
– With ∞ or § pressed, the display will increase or
decrease the alarm time rapidly and continuously from
minutes to hours.
– Press ∞ or § briefly and repeatedly to adjust the alarm
time minute by minute.
3. Release ∞ or § when you have reached the correct alarm
time setting.
4. Select your choice of alarm mode by pressing CD 2, BUZZER
or RADIO.
5. Release the ALM 1 or 2 button.
™ The display will show the selected alarm icon
•
under ALM 1 or ALM 2.
6. To review the alarm time, press your selected ALM 1 or 2
button.
appears in the display.
RADIO
, or
ALARM
11