Service, Maintenance And Care - Taski swingo 1260B Power Manual De Instrucciones

Service, maintenance and care

The maintenance of the machine is a prerequisite for impec-
cable operation and a long service life.
Attention:
Use original TASKI parts only; otherwise,
any warranty and liability claims will ex-
pire.
Attention:
In order to rule out unintended machine
functions, before starting maintenance
works the following must always be carried
out
- the machine must be switched off,
- the key can be removed.
Legend:
◊ = whenever cleaning is completed, ◊◊ = every week,
◊◊◊ = every month, ⊗ = service lamp
Activity
Loading batteries
Replenishing distilled water (wet-cell
batteries). Observe the service sheet of
the battery supplier!
Draining and cleaning the recovery and
fresh water tank (Flextank)
Clean all yellow marked parts
Clean the brushes
Clean the squeegee, check the blades
for wear and change them, if necessary ●
Wipe the machine using a damp cloth
Clean the seals of the tank lid, check
them for cracks and replace them, if
necessary
Maintenance and service program car-
ried out by Diversey service techni-
cians
Service intervals
TASKI machines are high-quality machines that have been
checked for safety in the factory and by authorized inspectors.
Electrical and mechanical parts are subject to wear and aging
after a longer period of use.
• In order to maintain operational safe-
ty and readiness for use, the ma-
chine must be serviced whenever the
maintenance indicator lights up (fac-
tory setting is 450 working hours) or
at least once a year.
Notice:
In case of extraordinary use and/or insuffi-
cient maintenance, shorter intervals are
required.
Service center
Please always indicate the type and number of the machine
whenever you contact us for order placing or in case of mal-
functions.
The required data are provided on the nameplate of your ma-
chine. The address of your closest TASKI service partner is
provided on the last page of these instructions of use.
Blade replacement
Blade in the inner radius
I
● 6
• Put the clean squeegee body with the rolls downward on a
solid surface (table, ground, etc.). (Detail I1)
● 7
• Loosen the screw (do not remove it completely) in the mid-
dle of the 2 parts of the tightening strap until the tightening
strap can be removed. (Detail I2)
● 11
• Clean squeegee body, blades and tightening strap under
running water with a brush.
●
• Mount the "turned" or new blade onto the squeegee body.
• Put the tightening strap in the right position on the blade
● 12
(Detail I3).
• Tension the tightening strap. (Detail I2)
11
Blade on the outer radius
● 12
A
●
●
• Put the clean squeegee body with the rolls downward on a
solid surface (table, ground, etc.). (Detail A1)
• Loosen the screws (do not remove them completely) on the
left and right side of the 3-part tightening strap until the
tightening strap can be removed. (Detail A2)
• Clean squeegee body, blades and tightening strap under
running water with a brush.
• Mount the "turned" or new blade onto the squeegee body.
• Put the tightening strap in the right position on the blade
(Detail A3).
• Tension the tightening strap. (Detail A2)
I2
I1
X < Y
X
Y
A2
A3
A1
X < Y
X
Y
EN
I3
I1
A2
A1
13