Alliance Laundry Systems HC18SN2 Operación Y Mantenimiento página 11

Display
FC 5 Program identification code (ROM)
(this is an example only)
HoLd Wait...power has just been turned on
PAY/(price)* Pay (flashes alternately with start price if
"FLSH" SETUP option is enabled)
CY Cycle (followed by two-digit number)
tESt/CYC* Test cycle selected
FAr Degrees Fahrenheit
CEL Degrees Celsius
HEAt Auxiliary heat enabled
noHt Auxiliary heat disabled
n
Strt/A t* Start amount – flashes briefly before
showing vend price in Setup Mode
Con1/deno* Coin 1 value – flashes briefly before
showing value of coin 1 in Setup Mode
Con2/deno* Coin 2 value – flashes briefly before
showing value of coin 2 in Setup Mode
PrE Prewash segment (1st of 8 segments)
UASH Wash segment (2nd of 8 segments)
FIL1 First fill (3rd of 8 segments)
FIL2 Second fill (4th of 8 segments)
FIL3 Third fill (5th of 8 segments)
FIL4 Fourth fill (6th of 8 segments)
FIL5 Fifth fill (7th of 8 segments)
FIL6 Sixth fill (8th of 8 segments)
AFIL Auxiliary fill
bFIL Warm fill (both hot and cold)
CFIL Cold fill
bLCH Add bleach (for supply 2 only)
1Pr One vend price – all cycles
16Pr 16 vend prices – one per cycle
CHEC/ Test cycle selected (same as tESt/CYC)
CYC*
For Wash speed forward in test cycle
FrEE "Free" cycle option
*Display indications separated by a slash (/) represent an alternating display.
F232137
Display Indications for V-Series – Coin
Meaning
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display
HFIL Hot fill
Lo Low water level
n
Ed Medium water level
HI High water level
SUP0 No supplies
SUP1 Supply 1
SUP2 Supply 2
SUP3 Supply 3
SUP5 Supply 5 (supply 1 and 2)
SUP6 Supply 6 (supply 2 and 3)
drAI/dISt* Distribution (load balancing before extract)
(Variable-speed only)
drAI/For* Drain step (low speed forward in test cycle)
n
SPIn/tI E* Reads "SPIn" for one second, then "tI
followed by time for spin
SdLY Spin coast delay
STOP Stop routine
donE Cycle and stop routine have ended
HI 1 Low spin in test cycle (Variable-speed only)
HI 2 High spin in test cycle (Variable-speed only)
bAL/FAIL* Balance routine failed during test cycle
SHUT/door* Door not properly closed
CANt/OPEN* Computer cannot unlock door after five
attempts
FILL/STOP* Programmed water level not reached after
30 minutes
FULL The computer detects low water level or higher
when none should be present
dFLt Drive fault detected (Variable-speed only)
tSFL Temperature sensor failure or temperature out
of range
bAL? Special factory balance setup mode
SPC? Special factory valve flush mode
SPIN Spin in test cycle (2 speed only)
rEv Reverse wash speed in test cycle
Table 2
Operation
Meaning
n
E"
9