Alliance Laundry Systems HC18SN2 Operación Y Mantenimiento página 13

Display
F23n Program identification code (ROM)
(this is an example only)
HoLd Wait...power has just been turned on
CY Cycle (followed by two-digit number)
tESt/CYC* Test cycle selected
FAr Degrees Fahrenheit
CEL Degrees Celsius
HEAt Auxiliary heat enabled
noHt Auxiliary heat disabled
tFIL Temperature-controlled fill enabled
ntFL Temperature-controlled fill disabled
CooL Automatic cool-down enabled
noCL Automatic cool-down disabled
Ag 1 Agitation 1 selected (90% agitation)
Ag 2 Agitation 2 selected (33% agitation)
Ag 3 Agitation 3 selected (10% agitation)
Ag 4 Agitation 4 selected (6.7% agitation)
n
PU P Pump output enabled (future use only)
n
nP P Pump output disabled (future use only)
PrE Prewash segment (1st of 11 segments)
UASH Wash segment (2nd of 11 segments)
FIL1 First fill (3rd of 11 segments)
FIL2 Second fill (4th of 11 segments)
FIL3 Third fill (5th of 11 segments)
FIL4 Fourth fill (6th of 11 segments)
FIL5 Fifth fill (7th of 11 segments)
FULL The computer detects low water level or
higher when none should be present
tSFL Temperature sensor failure or
temperature out of range
*Display indications separated by a slash (/) represent a flashing display.
F232137
Display Indications for V-Series Two Speed – Non-Coin
Meaning
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display
FIL6 Sixth fill (8th of 11 segments)
FIL7 Seventh fill (9th of 11 segments)
FIL8 Eighth fill (10th of 11 segments)
FIL9 Ninth fill (11th of 11 segments)
CFIL Cold fill
bFIL Warm fill (both hot and cold)
HFIL Hot fill
AFIL Auxiliary fill (Setup option)
Lo Low water level
n
Ed Medium water level
HI High water level
SUP1 Supply 1
SUP2 Supply 2
SUP3 Supply 3
SUP4 Supply 4
SUP5 Supply 5 (or Setup option)
SUP6 Supply 6 (supply 1 and 5)
SUP7 Supply 7 (supply 3 and 4)
For Wash speed, forward direction
rEv Wash speed, reverse direction
drAI Drain enabled
nodr Drain disabled
STOP Stop routine
SdLY Spin coast delay
donE Cycle and stop routine have ended
door Door not properly closed
FILL/STOP* Programmed water level not reached
after 30 minutes
n
SPIn/tI E* Reads "SPIn" for one second, then
"tI
Table 4
Meaning
n
E" followed by time for spin
Operation
11