Connecting The Power Cable(S) - Dell PowerVault NX3500 Manual De Instrucciones

Connecting the Power Cable(s)

Connect the system's power cable(s) to the system.
CAUTION:
C-13 output receptacles. Only use a power cord rated for the input power source
rating labeled next to the input connector on the power module back panel.
CAUTION:
Vac into a 120 V BPS will damage the BPS.
Open the spring-loaded interlock cover for the input connector and connect the
power cable to the BPS.
10
Getting Started With Your System
Both the 120 V (LV) and the 230 V (HV) power modules provide IEC 320
You must always verify the voltage rating of the BPS. Connecting a 230