Metabo HPT STRAP-TITE NR 3665DA Instrucciones Y Manual De Seguridad página 21

□ Probe and Nail support (B) are surely mounted on
and no defect.
Probe
Never look into the fi ring head.
(2) Installing the battery.
Do not operate the push lever or trigger while
installing the battery.
Latch
(3) Turn on the Power switch.
Power indicator
Nail support (B)
WARNING
Handle
Battery
Push
Insert Pull out
Power
Nailing operation
switch indicator
Turn on the Power switch by push and hold on Power
switch more than 1 second.
Make sure the power indicator is lighting in green,
and nailing operation indicator is lighting in blue.
(FULL SEQUENTIAL ACTUATION MECHANISM,)
NOTE
● Do not press the push lever and/or pull the trigger
during the process of turning the power switch ON.
Doing so will prevent the power switch from turning ON.
Light in green
[Auto power off ]
When the power is turned on but the Nailer is not
used for 30 minutes, the Nailer is automatically
turned off . To turn on again, press the power switch.
Never leave the Nailer with the power on. This
could result in an accident.
Nailing operation indicator
Lighting (Blue):
FULL SEQUENTIAL ACTUATION MECHANISM,
Make sure the battery indicator is not blinking.
(page 26, Table 5)
If the battery indicator is blinking, the battery doesn't
have enough power and it needs to be charged.
(4) Remove the fi nger from the trigger and press the
push lever against the workpiece with pulling back
the feeder knob.
□ THE NAILER MUST NOT OPERATE.
Do not pull
the trigger
Depress
push lever
(5) Separate the push lever from the workpiece.
Next, point the nailer downward, with pulling back
the feeder knob, pull the trigger and then wait in that
position for 5 seconds or longer.
English
Light in blue
WARNING
Pulling back
feeder knob
21