Methods Of Operation - Metabo HPT STRAP-TITE NR 3665DA Instrucciones Y Manual De Seguridad

English

METHODS OF OPERATION

This Nailer is equipped with the push lever and does not
operate unless the push lever is depressed.
There is a method of operation to drive nails with this
Nailer.
It is intermittent operation (Trigger fi re) only.
(Nailing operation indicator is light in blue.)
● Confi rm that the nailing operation indicator is
lit in blue.
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Pull the trigger rapidly and fi rmly.
2) Use the probe to ensure nails were fi red
accurately into the holes.
Set probe into the hole of the metal connector
securely with fi nger off the trigger.
Metal
connector
To operate the Nailer, hold perpendicular to the
workpiece.
Depress the push lever fi rmly until it is completely
depressed.
Pull the trigger to drive a nail.
Remove fi nger from the trigger and lift the tool off
the workpiece completely.
To continue nailing in a separate location, move the
nailer along the metal connector, repeating steps
- as required.
24
WARNING
Probe
Hole
Wood
NOTE
● Operations and
2 seconds of each other. If more than 2 seconds
pass after , the Nailer will not work properly. If this
happens, retry from
● The push lever cannot be pressed all the way in
unless the Nailer is perpendicular to the workpiece.
Nailing operation indicator
(Light in blue)
Push lever
● Keep your fi nger off the trigger except during
nailing operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT nailer may
bounce from the recoil of driving a nail and
unwanted subsequent nail may be driven,
possibly causing injury.
NOTE
● If all warnings and instructions are followed, safe
operation is possible with all systems.
● Always handle nails and package carefully. If nails
are dropped, collating bond may be broken, which
will cause mis-feeding and jamming.
● After nailing:
1) remove battery from the Nailer;
2) remove all nails from the Nailer
should be done within
.
Trigger
WARNING