Water Drainage - Klarstein AeroDry 10 Manual De Instrucciones

Water Drainage

When the water tank is full, the unit will stop automatically. When this happens the TANK
FULL red light will show on the control panel.
Note: Only empty the water tank when is full or before moving or storing the unit.
There are two ways to dispense collected water:
1 Use the tank:
• When the tank is full, the unit will automatically stop running, and the TANK FULL
indicator light will flash.
• Slowly pull out the tank. Grip tank by its handle securely, and carefully pull out.
• Empty the water tank and reinsert it into the dehumidifier.
• The tank must be in place and securely seated for the dehumidifier to operate
again.
• The dehumidifier will re-start when the tank is restored in its correct position.
Note: When you remove the bucket, do not touch sensors or any parts which are
situated behind tank. Doing so may damage the product. Be sure to push the tank
gently all the way into the unit. Banging the bucket against anything or failing to
push it in securely into place may cause the unit not to operate.
Do not remove any parts from the water tank or tank enclosure. The water full sensor
will no longer be able to detect the water level correctly and water may leak from
the water tank.
EN
35