Klarstein AeroDry 10 Manual De Instrucciones página 36

EN
36
2 Continuous draining:
• Water can be automatically plumbed in or drained into a sink, a larger recipient
or through the wall into an outside drain by attaching a pipe with 10 mm internal
diameter to the unit (not included).
• Insert the pipe into the drain outlet at the back of the unit as shown here.
• Make sure the connection between pipe and the drain outlet is tight and does not
leak. Then direct the pipe to a suitable drainage point.
• This unit uses gravity fall to dispose water hence the drain should be lower than the
unit water outlet. Put the tank back. Be sure to run the water pipe downward and let
the water to flow out smoothly. Do not kink or bend the pipe.
Note: When the continuous drain feature is not being used, remove the drain hose
from the outlet.
• The permanent drain can be used in conjunction with water pump (e.g. when
draining a cellar) to lift the water upwards.