Weee Directive - Cosatto SUPA NITTY GRITTY Manual De Instrucciones

WEEE directive

In line with EU Directive 2002/96/EC for waste electrical and electronic equipment
(WEEE), the speaker must not be disposed of as unsorted municipal waste.
Please dispose of this component by returning it to the point of sale or to your
local municipal collection point for recycling.
operation
(see illustrations further on in this booklet)
1 - list of parts
Your pushchair is supplied in one carton and contains:
1. Pushchair (basket attached)
2. Hood
3. Footmuff
4. Raincover
Note: The style of the wheel may vary between models.
2 - opening the pushchair
To open the pushchair, first release the autolock (a) which holds the pushchair in the umbrella
position. Now holding the pushchair by its handles, gently lower the front. To complete the
operation, press hard on the pedal (b), until you hear the 'click' from the secondary locking bar (c).
WARNING:
•
engaged before use.
3 - using the brake
To apply the brake, press either lever down firmly with your toe (a). Test the brake is engaged
correctly by trying to push the pushchair forwards for a short distance. To release the
brake, raise either of the levers (b).
NOTE: Always apply brake before loading or unloading a child from the pushchair.
4 - using the front wheels
To allow the front wheels to swivel, push down on the locking lever as shown (a). To lock the
wheels into position lift the locking lever up (b) with the wheels in any position and run the
pushchair until you hear each wheel 'click' as they lock in position.
5 - adjusting the handle height
To raise the handles press the buttons (a) on the inside of each upper hinge. The handles will
automatically spring to a higher position.
To lower the handles press the buttons again (b) then push the handles down (c). Release the
buttons but keep pressing down on the handles until they lock in place.
6 - using the harness
A five point harness is provided to restrain your child. To fasten the harness push clips into buckle
(a). To unfasten push the button in the centre of the buckle (b) and remove the clips.
Sliding adjusters are fitted on the waist strap and should be carefully adjusted so the harness fits
your child comfortably. To adjust to the smallest size you will need to thread the adjusters through
the "D" ring.
'D' rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210.
The length of each strap can be changed by using adjusters (c), (d) & (e).
WARNING:
•
combination with the waist belt.
5. Plastic drinks holder
6. Speaker
7. Changing bag (If specified)
Ensure that all locking devices are
Always use the crotch strap in