Rear Panel; Technical Specification - Blackstar Amplification HT-5 El Manual Del Propietario

Rear Panel

1. Mains Input
The supplied detachable mains lead is connected here. The lead should only be
connected to a power outlet that is compatible with the voltage, power and
frequency requirements stated on the rear panel. If in doubt get advice from a
qualified technician.
2. Speaker Outputs
The output marked '1x16 Ohm' is for the connection of a single 16 Ohm extension
speaker cabinet (or the internal loudspeaker of the HT-5 combo).
The outputs marked '1x8 Ohm or 2x16 Ohm' are for the connection of either a single
8 Ohm extension cabinet or two 16 Ohm cabinets. Also, the internal loudspeaker of
the HT-5 combo can be plugged in here if it is used with a 16 Ohm extension cabinet.
See table below.
Internal 16 Ohm combo speaker
One 16 Ohm extension cabinet
Two 16 Ohm extension cabinets
Single 8 Ohm extension cabinet
WARNING: The output marked '1x16 Ohm' should never be used at the same time
as either of the outputs marked '1x8 Ohm or 2x16 Ohm'.
3. Footswitch
ThThe supplied footswitch is connected here. The footswitch enables you to switch
between the Clean and Overdrive channels.
4. Effect Loop Send
Connect the (mono) input of an external effects unit here.
5. Effect Loop Return
Connect the (mono) output of an external effects unit here.
6. Effect Loop Level
The Effect Loop Level switch sets the effects loop to either +4dBV/-10dBV, which
enables you to use it with either professional equipment (+4dBV setting), or with
guitar level effects such as effects pedals (-10dBV setting).
10
'1x16 Ohm' output '1x8 Ohm or 2x16 Ohm' outputs
X X
X X
X
X X

Technical Specification

HT-5 Combo
Power (RMS): 5 Watts
Valves: 1 x ECC83, 1 x 12BH7
Weight (kg): 11.5
Dimensions (mm): 442 x 430 x 235
Footswitch: FS-1 supplied
HT-5H Head
Power (RMS): 5 Watts
Valves: 1 x ECC83, 1 x 12BH7
Weight (kg): 7.6
Dimensions (mm): 442 x 223 x 226
Footswitch: FS-1 supplied
HT-110 Extension Cabinet
Power Rating (RMS): 40 Watts
Impedance: 16 Ohms
Speaker: 1 x 10˝ Celestion
Weight (kg): 10.6
Dimensions (mm): 442 x 442 x 247
11