Factory Reset; Front Panel - Blackstar Amplification SILVERLINE STANDARD El Manual Del Propietario

Factory Reset

The default factory patches and settings can be restored to your amplifier at any
time. Simply hold down the MOD, DLY and REV switches simultaneously, whilst
switching on the amplifier. The bank LED will illuminate, and change from green, to
orange, to red, to indicate that a factory reset is imminent. This process will take a
total of two seconds. If any of the MOD, DLY and REV switches are released before
the bank LED has cycled through all colours and switched off, then the operation is
cancelled and the amplifier will remain unaffected.
IMPORTANT NOTE: This process will overwrite any user content
8
All manuals and user guides at all-guides.com

Front Panel

1. Input
Plug your guitar in here. Always use a good quality screened guitar lead.
2. Voice
The Voice control changes the preamp voicing, ranging from ultra clean to extremely
overdriven.
 Clean Warm – Classic clean, dynamic
 Clean Bright – 'Boutique', will break up when pushed hard
 Crunch – Classic medium gain overdrive
 Super Crunch – More gain and punch than Crunch
 OD 1 – Hot-rodded Master Volume overdrive
 OD 2 – Mid boosted overdrive
This setting is saved when you store a patch.
3. Gain
The Gain control adjusts the amount of overdrive or distortion. Low settings, counter
clockwise, will deliver a clean sound on the edge of break-up. As the Gain control is
turned clockwise the sound will become more overdriven, moving through beautiful
crunch tones until, at its maximum position, a full distorted tone is achieved. This
setting is saved when you store a patch.
4. Volume
This controls the preamp volume. Turning it clockwise increases the volume.
High levels of volume will introduce the effect of valve power amp distortion and
compression, depending on the Response (9) setting you have selected. This setting
is saved when you store a patch.
5. Bass
The bass control adjusts the amount of low-end frequencies in your tone. This amp
has an advanced tone shaping circuit which allows the tone to be tight and cutting
(counter clockwise) to warm and thumping (clockwise). This setting is saved when
you store a patch.
6. Treble
The treble control allows exact adjustment of the treble frequencies within the sound.
At low settings (counter clockwise) the sound will be warm and dark in character.
As the treble control is increased (clockwise) the sound will become brighter. At the
maximum settings the sound will be aggressive and cutting. This setting is saved
when you store a patch.
9