Install Appliance; Attaching Pipe Connections - Gaggenau VL 040 714 Instrucciones De Instalación

Install Appliance

,
WARNING:
Before you plug in an electrical
cord or turn on power supply, make sure all
controls are in the OFF position.
1
Mark the center of the recess exactly. Fit the long
mounting rail to the front, the short mounting rail
to the rear of the recess. Make sure the lugs of
the mounting rails lie on the worktop. The center
marking on the mounting rail must be precisely
flush with the center marking of the recess.
Note: when fitting the appliance in a stone
countertop glue on the mounting rails with a
temperature-resistant two-component adhesive
(metal on stone).

µ
 PP
µ
 PP
2
Lower the appliance into the cut-out. The snap-in
pins on the appliance must lie exactly on the
catch springs. Firmly press the appliance into the
The pins on the appliance must snap
cut-out.
into the catch springs.

Attaching pipe connections

Note: If an aluminum pipe is used, first smooth the
connection area.
Exhaust pipe
1
2
Pipe dimensions
Note: The manufacturer of the device accepts no
liability for claims caused by the piping.
▯
▯

µ
 PP
µ
 PP
Attach exhaust pipe to air connecting piece.
Seal both junctions appropriately.
The device achieves optimum performance
through a short, straight ventilation pipe and the
largest possible pipe diameter.
With long, coarse exhaust pipes and many pipe
bends, the optimum suction performance is not
achieved and fan noise becomes louder.
5