Definition Of Terms; Operating Procedure - Campbell Hausfeld WL6100 Serie Manual Del Usuario

Operating Instructions
Operation

DEFINITION OF TERMS

Pressure Switch - Auto/Off Switch - In
the AUTO position, the compressor
shuts off automatically when tank
pressure reaches the maximum preset
pressure. In the OFF position, the
compressor will not operate. This
switch should be in the OFF position
when connecting or disconnecting the
power cord from the electrical outlet or
when changing air tools.
ASME Safety Valve - This valve
automatically releases air if the tank
pressure exceeds the preset maximum.
Discharge Tube - This tube carries
compressed air from the pump to the
check valve. This tube becomes very hot
during use. To avoid the risk of severe
burns, never touch the discharge tube.
Check Valve - One-way valve that
allows air to enter the tank, but
prevents air in the tank from flowing
back into the compressor pump.
Drain Valve - This valve is located on
the bottom of the tank. Use this valve
to drain moisture from the tank daily
to reduce the risk of corrosion.
Regulator - The regulator controls the
amount of air pressure at the hose
outlet. Turning regulator knob
clockwise (to the right) will increase air
pressure at the outlet. Turning knob
counterclockwise (to the left) will lower
air pressure to the outlet. Turning knob
fully counterclockwise will shut off flow
of air completely.
Pressure Gauges - These gauges will
show air pressure in the compressor
tank and at the compressor outlet.
Outlet Pressure Gauge - Will show air
pressure at the outlet in pounds per
square inch (psi). Make sure this gauge
reads ZERO (by adjusting regulator
Minimum Gauge
of Extension Cord
25 ft. 50 ft.
14 12
www.chpower.com
Figure 4
knob fully counterclockwise) before
changing air tools or disconnecting air
hose from outlet.
Tank Pressure Gauge - Will show air
pressure in tank while the compressor is
running, indicating compressor is
building pressure properly. This gauge
will show maximum pressure of
compressor when it shuts off
automatically at the pressure switch.
LUBRICATION
This is an oilless product and does not
require lubrication to operate.
chuck or other tool to open end of hose
until start-up has been completed and
unit checks OK.
IMPORTANT: Do not operate
compressor before reading instructions
or damage may result.
100 ft.
10
Tank Pressure
Gauge
Drain Petcock
Outlet Pressure
Gauge
Do not
attach air
4
Regulator
Pressure Switch
Safety
Valve
Air Hose
Attachment

OPERATING PROCEDURE

1. Turn switch to OFF position and plug
in power cord.
AUTO
OFF
Figure 5
2. Turn regulator knob
counterclockwise to close air flow.
3. Turn switch to AUTO position.
4. Compressor will build to maximum
pressure and shut off.
5. With hose attached to outlet of
compressor, attach tire chuck or
other tool to open end of hose.
6. Adjust regulator to proper pressure
for tool or tire. Operate tool per
instructions.
As air is depleted from the tank by use
of a tire chuck, tool, etc., the
compressor will restart automatically at
its preset "cut-in" pressure. When a
tool is being used continuously, the
compressor will cycle on and off
automatically.
7. Turn switch to OFF position, unplug
power cord and drain tank of air
when finished using compressor.
Tank
Pressure
Gauge
Safety
Valve
Regulator