Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Description
1 Shaver foil
2 Cutter block
3 Release button
4 «on/off» switch
5 Long hair trimmer
6 Dual function light
green: charging
red:
low-charge
7 Special cord set
Charging
The best environmental temperature for char-
ging is between 60 °F to 95 °F/15 °C to 35 °C.
•
Using the special cord set, connect the
shaver to an electrical outlet with the motor
switched off.
•
When charging for the first time, leave the
shaver to charge continuously for 4 hours.
Subsequent charges will take about 1 hour.
•
As soon as you start charging the shaver,
the green charging light (6) comes on.
When the batteries are fully charged, the
green light intermittently blinks on and off.
This indicates that the battery maintains its
full capacity.
•
Once the shaver is completely charged,
discharge the shaver through normal use.
Then recharge to full capacity.
•
A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
•
When the batteries are running low, the
dual function light (6) turns red (provided
the shaver is switched on). The red light
indicates the shaver capacity has dropped
below 20%, which is sufficient for 2 to 3
shaves.
•
If the rechargeable batteries are dis-
charged, you can shave without charging
by connecting the shaver to an electrical
outlet via the special cord set.
6
Shaving
Press the «on/off» switch (4) to turn the shaver
on.
Trimmer: When the long hair trimmer (5) is
activated, it allows controlled trimming of
moustache or sideburns.
Tips for the perfect shave
•
It can take up to 14-21 days for your
beard to adjust to the new shaving
system.
•
Shave before washing your face or taking
a shower, as skin tends to swell after
washing.
•
The dryer the skin, the closer the shaving
results will be.
•
Hold the shaver at right angles (90°) to the
skin. Stretch the skin and shave against
the direction of beard growth.
•
To maintain 100% shaving performance,
replace your foil and cutter block every 18
months or when worn.
Cleaning
The hand-held unit shall be detached from
the power supply cord before cleaning. The
shaver shall not be used until it has dried.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head after
each shave under hot running water is an easy
and fast way to keep it clean:
•
Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
A natural based soap may also be used
provided it contains no particles or
abrasive substances. Rinse off all foam and
let the shaver run for a few more seconds.
•
Next, switch the shaver off and press the
release buttons. Lift the shaver foil off and
pull the cutter block out. Then leave the
disassembled shaving parts to dry.
Alternatively, you may clean the shaver using
the brush provided:
Publicidad
Tabla de contenido
