Drive Rolls; Replacing The Pressure Rocker En - Abicor Binzel MF1 Instructivo De Servicio

MF1
7 Remount all components in reverse order.

6.1.2 Drive rolls

 Fig. 3 Putting into operation on page EN-10
NOTICE
• Red drive rolls = V-groove / blue drive rolls = U-groove / green drive rolls = knurled V-groove.
• An engraved number indicates the wire diameter to be used.
1
Fig. 4
 Fig. 3 Putting into operation on page EN-10
1 Unscrew drive roll knurled screws (3).
2 Place feed drive rolls (2) on drive gears (5).
3 Remount drive roll knurled screws (3).
6.1.3 Replacing the pressure rocker
 Fig. 3 Putting into operation on page EN-10
1 Lift off the protection cap (1).
2 Rotate the eccentric bolt (9) and remove it upwards.
3 Open the pressure rocker (7).
4 Unscrew the knurled screw (8).
5 Remove the pressure rocker upwards.
6 Place the new pressure rocker on the rotation axis and secure it with the knurled screw (8).
 Fig. 4 Wire feed roll knurled V-groove on page EN-11
1
Wire feed roll
Wire feed roll knurled V-groove
6 Putting into operation
2 Engraved number for the wire diameter
2
EN - 11