Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. Camera Installation
4-1. Pre-work before installation
Make holes for
cables and to fix a
camera.
For the hole for
cable, a diameter of
the opening should
be at least 50mm to
60mm. Please make
it with utmost care
not to give damage to wires.
4-2. Mounting the camera
(Ceiling)
1. Put a rubber sealing gasket
on the housing base, paying
attention to allow for the screw
holes.
2. Take the dome cover off by
loosening the three screws with
the supplied L-form wrench.
3. Install the main unit to the
ceiling with supplied four
screws.
4. Replace the dome cover, after
making final camera setup
selections and lens adjustment.
4-3. Mounting the camera (Wall)
The way of installation is the almost same as to a
ceiling.
Install the main unit so that the switch becomes
upper side as shown in the illustration right and
set the "FLIP" in the setup menu to "V-FLIP".
Holes for camera
fixing
E-3
83.5
cables on the ceiling
Front side
Rubber sealing
Attaching screws to
Size of hole for
ø50 - ø60
gasket
Camera
secure camera
(four)
Dome cover
L-form wrench
Upper
Lower
Publicidad
Capítulos
Tabla de contenido
