Draining Solution Tank; Machine Maintenance; Daily Maintenance - Tennant 5200 Manual De Operación Y De Piezas

Ocultar thumbs Ver también para 5200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Remove drain hose from holder, position hose
over floor drain and twist off drain hose plug. To
completely drain recovery tank, hinge open tank
and flip up tank support stand to rest tank on
(Figure 16).
FIG. 16
2. Clean recovery tank after each use. Use a hose to
rinse out recovery tank. Be careful not to spray
water into float shut-off screen.
3. Replace drain hose plug tightly after draining.

DRAINING SOLUTION TANK

To drain leftover cleaning solution from solution tank
perform the following steps:
1. Pull clear tube off hose barb at rear of machine
and drain solution into floor drain or bucket
(Figure 17).
FIG. 17
2. Rinse solution tank with clean water after each
use. This will prevent clogging due to chemical
buildup.
3. Push solution flow lever forward to rinse out
solution flow system.
4. Reconnect clear tube. Be certain tube is
completely pushed on hose barb.
Tennant 5200 Electric (11–01)
Home Find... Go To..

MACHINE MAINTENANCE

To keep machine in good working condition, simply
follow machines daily and monthly maintenance
procedures.
WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.
ATTENTION: Contact an Authorized Service
Center for machine repairs. Machine repairs
performed by other than an authorized person will
void your warranty.

DAILY MAINTENANCE

(Every 4 Hours of Use)
1. Inspect power cord and cord grip for damage.
Replace immediately if damaged. Always coil
extension cord neatly after each use.
2. Remove and clean pad/brush.
3. Remove and clean float shut-off screen located in
recovery tank (Figure 18).
FIG. 18
4. Drain and rinse tanks thoroughly. After draining
tanks, hinge recovery tank until you can see
vacuum intake hole at rear of tank. Remove any
debris in hole if necessary.
5. Raise squeegee and wipe it down with a dry cloth.
Store squeegee in the up position to prevent
squeegee damage.
6. Clean machine with an all purpose cleaner and
damp cloth.
OPERATION
9

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

609601

Tabla de contenido