Technical Information; Installation Notes - Hansgrohe Metris 31101 1 Serie Instrucciones De Montaje / Manejo / Garantía

English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate 0.09 gallons per cycle / 0.5 GPM**
Hole size in mounting surface
Max. depth of mounting surface
Battery
Automatic shutoff

Installation notes

• Flush the hot and cold supplies thoroughly before
installing the faucet. Damage to the faucet caused
by debris is not covered under the warranty.
• The hot and cold supplies should be of equal
pressure.
• The faucet should not be used with a continuous
flow water heater.
• Do not install the faucet on a sink with a raised
edge.
• Strong light sources should not shine directly on the
sensor window of the faucet.
• The faucet should only be used with the battery
pack or power pack supplied by Hansgrohe. Do
not attempt to use any other battery pack or power
pack.
• The faucet incorporates automatic range adjustment
-- the sensor automatically adjusts itself to local
conditions (lavatory, brightness, etc.)
• The distance between the switch on/off point
to the faucet is approx. 6¼" - 8" under normal
conditions. The detection area may be less for dark,
non-reflective objects, or greater for bright, highly
reflective objects.
If the sink is very small or highly reflective,
follow the range reduction instructions on
page 14. When the faucet is in reduced range
mode, the LED in the sensor window will flash while
the faucet is not in use.
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
1⅜"
1⅝"
CR-P2 / 6V Lithium
after 10 seconds***
*Please know and follow all applicable local plumbing codes
when setting the temperature on the water heater.
** 0.09 gallons per cycle, 10 second maximum cycle time,
maximum flow 0.5 gallons per minute
***This is the maximum amount of time the faucet will run
while a hand is within range of the sensor.
• Drops of water or condensation on the sensor
window may cause the faucet to run.
• If the LED in the sensor window flashes while the
faucet is in use, the battery is low, but the faucet may
still be used. If the LED stays on, the faucet will not
run, and the battery must be changed.
The spray pattern will be unattractive
immediately after installation or service,
due to air in the faucet. After the faucet is
used 10 - 15 times, the spray pattern will
clear.