Thermal Disinfection - Hansgrohe Metris 31101 1 Serie Instrucciones De Montaje / Manejo / Garantía

English
Hansgrohe recommends not to use as drinking water
the first half liter (approximately 1 pint) flowing from
the faucet in the morning, or after prolonged non-use.
Hygiene rinse
• The hygiene rinse opens the faucet for 10 seconds
every 24 hours following the last use.
• To enable or disable the hygiene rinse:
• Interrupt voltage supply of the faucet for approx.
10 seconds (disconnect electrical plug connection
between faucet and battery housing and reconnect
after 10 seconds).
• The LED blinks to indicate the software version (e.g.
blinking once = software version 1).
• Permanent light from the LED indicates that
calibration of the infrared proximity electronics is in
progress.
• Wait for LED to go out.
• Cover sensor window completely with your hand or
a white piece of paper.
• Remove your hand or the paper after 10 seconds.
• The currently enabled mode is indicated by the
flashing of the LED: 1x = enabled, 2 x = disabled.
Permanent rinse
• After setting the parameters for the hygiene rinse or
making a net reset, wait for approx. 100 seconds
before you can enable the "Permanent rinse"
function.
• Cover the sensor window completely with your
hand or a white piece of paper.
• The faucet opens briefly and then closes
immediately. When the faucet opens again after
approx. 5 seconds, remove the hand or the paper
from the sensor.
• Permanent rinse is enabled for 3 minutes and can
be interrupted at any time by a movement in the
sensor range.

Thermal disinfection

Thermal disinfection must only be carried
out by qualified personnel.
• Risk of scalding with thermal disinfection!
• The cold water stop must be closed during thermal
disinfection.
• Afterwards, "Permanent rinse" can be enabled.
Net reset
• A "net reset" returns the faucet to the original factory
settings.
• Interrupt the voltage supply to the faucet.
• Briefly reach into the sensor range of the faucet to
discharge the capacitor.
• Wait for approx. 10 seconds, then plug the
connectors in again.
The faucet will re-adjust during the next 30
seconds. Do not reach into the sensor range
during this period of time.
3