Installing Network Cables; Station Connections; Switch-To-Switch Connections; Module Installation - Longshine LCS-SW2402S Manual Del Usuario

4.3 Installing Network Cables

After placing the switch on the desktop, we need to know how to connect the
device to network.

Station Connections

Reference to the wiring statement of the previous section; connect each station to the
switch with correct type of cables.

Switch-to-Switch Connections

In making a switch-to-switch connection, use Gigabit ports to connect another switch
or backbone is strongly recommended. The Gigabit ports provide the fat pipe to the
server or backbone connectivity for boosting the total system performance. Reference
to the wiring statement of the previous section; connect each station to the switch with
correct type of cables.
Furthermore, as the switch supports port aggregation (port-trunk) capability and up to
7 groups, it is also great to build up switch-to-switch connectivity. For detail
information, please reference to the "Management Guide" session.

4.4 Module Installation

The three slide-in slots on the front and rear panel are purposed for installing
optional modules. They can be used as a network backbone or connect to a server.
Follow the steps as described to install a module:
1. Power off the switch
2. Removing the two screws on the face plate of slide-in slot with a flat-head
screwdriver
3. Push the module gently into the slot along the slide tracks
4. Ensuring that it firmly engages with the connector then tighten the screws to
secure the module
Attention The slide-in slots are not hot swappable, power off the switch
before installing modules
E-20