Longshine LCS-SW2402S Manual Del Usuario página 53

To remove a static address
1. Click the static address in the MAC address table of the port
2. Click "Remove>>" button to remove it from MAC address table
Mirror
Port mirror is used to mirror traffic from source port to a target port for analysis. Only
2 ports can be monitored (mirrored) simultaneously to 1 sniffer port (target port).
(Note that the target port must be in the same VLAN as the source port)
1. Click "Active" radio button to activate port mirror
2. Select 'Monitored Ports' (up to 2 ports)
3. Click 'Sniffer Port' combo box and select a sniffer port (target port) and click
"Apply" to apply
4. This figure describes port 2 and port 3 will be mirrored to port 11
E-52