Sub-Zero ICB424 Instrucciones De Instalación página 12

Models ICB427 and ICB427R Installation
Lock Installation
For models ICB427 and ICB427R, the optional lock is
attached to the decorative door panel through a field-
drilled hole in the panel. The catch should be installed on
the top of appliance cabinet before the unit is moved into
position. The accessory lock kit and additional instructions
are available through your Sub-Zero dealer.
IMPORTANT NOTE: For accessory stainless steel panels
requiring a lock, panels must be ordered with the lock
mounting hole pre-drilled.
Position the Unit
Remove the decorative top and side moldings and the
kickplate/grille of the wine storage unit.
IMPORTANT NOTE: If for any reason the wine storage unit
has been laid on its back or side, you must allow the unit
to stand upright for a minimum of 24 hours before con-
necting power.
Plug the power supply cord into the 15 amp grounded
electrical outlet. With power applied to the appliance,
check for lighting and cooling before going any further.
Once you are satisfied that the unit is operating properly,
shut off power to the electrical outlet at the circuit breaker
and proceed.
Shut off the power to the electrical outlet.
If a home alarm system is to be used with the wine
storage unit, the lead wires should be threaded into the
compressor compartment before you position the unit.
Refer to wiring connections on page 13 for the location of
these lead wires. After the unit is in position, the alarm
wiring can be completed from the front.
Pre-level the wine storage unit before rolling into position.
This is to allow the unit to engage the anti-tip bracket
properly.
Roll the unit into position, making sure the anti-tip bracket
is engaged properly. Screw the front leveling legs out
approximately 5 mm to make any future adjustments
easier.
IMPORTANT NOTE: When the wine storage unit is
installed, the anti-tip bracket will be positioned just below
the engaging bracket on the unit. It is not necessary to
raise the unit up so that it locks into the anti-tip bracket,
but the unit must be in alignment with the anti-tip bracket.
IMPORTANT NOTE: The floor under the wine storage unit
must be at the same level as the surrounding finished floor
to allow for removal of the unit for servicing.
Leveling
Level the unit by turning the front leveling legs clockwise
to raise the unit, or counterclockwise to lower it. To assist
you in adjusting the front leveling legs up or down, use a
standard screwdriver blade and place it in the front
leveling leg as shown in the illustration below.
The rear leveling legs are adjusted from the front of the
base by turning the Phillips head screw. Refer to the illus-
tration below.
IMPORTANT NOTE: The rear leveling legs will only move
2 mm for every 18 revolutions on the Phillips head screw.
Do not over torque. Use the lowest torque setting on any
power screwdriver. Do not turn the rear leveling legs by
hand. Damage will occur if you turn these legs.
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the
floor.
Front leveling leg adjustment. Rear leveling leg adjustment.
Install Molding
The decorative white molding strips for the top and sides
of models ICB427 and ICB427R can be snapped into
place as shown in the illustrations below. The top molding
piece must be installed before the side molding can be
attached. For installations where units are positioned side
by side, refer to side panels on page 15.
TOP MOLDING
Top molding installation.
Side molding installation.
12