Fume Extraction; Installation Underneath Extraction Hood - Gastrodomus GFP745 Manual De Instrucciones, Uso Y El Mantenimento

1.2 POSITIONING

1.3 FUME EXTRACTION

The appliances must be installed in compliance with installation regulations in premises with adequate fume evacuation
systems.

INSTALLATION UNDERNEATH EXTRACTION HOOD

Pag. 12
Remove the appliance from the packing, check it
for damage and place it in the installation position.
Level it and adjust its height by using the leveling
feet indicated in (Fig. 1).
If the appliance is placed against a wall, this must
be able to withstand temperatures of 80°Cand if it
is not inflammable, heat insulation must be
installed. Remove the protective film from the
external panels slowly to prevent glue remnants
remaining on them.
Do not obstruct the aspiration or heat
discharge openings and gaps and place the
appliance underneath an extraction hood that
complies with current standards.
If the appliance is installed underneath an extraction
hood, comply with the following instructions:
The volume extracted must be greater than the volume
of burnt gas generated (see current regulations).
The gas supply to the appliance must be controlled
directly by the supply system and must be cut off
immediately pressure falls below the prescribed
values.
It must be possible to reconnect the gas supply to the
appliance only manually.
This must be fitted after the oven has been positioned
underneath the extraction hood.
The end of the appliance's evacuation pipe must be
placed inside the hood's base perimeter (Fig. 2).