Memorising Safety Edge Transmitters; Memorising A Resistive Safety Edge Transmitter; Memorising An Optical Safety Edge Transmitter; Clearing The Remote Controls - SOMFY HOME MOTION ROLLIXO RTS Manual De Instalación

Rollixo RTS

MEMoRIsING sAfEty EDGE tRANsMIttERs

Memorising a new radio safety edge transmitter overwrites the previous transmitter.

Memorising a resistive safety edge transmitter

The transmitter must already be installed and the resistive safety edge
must be connected to the transmitter.
[1]. Press button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press the button on the back of the safety edge transmitter 5 times.
The safety edge transmitter indicator light comes on with each press and
after the 5th press remains constantly lit for 4 seconds and then flashes for
4 seconds.
Indicator light 2 on the receiver goes out and the receiver Prog indicator
light will flash and then go out (this may take a few seconds, the time
required for the transmitter and receiver to communicate with each other).
The transmitter is memorised in the receiver.
[3]. Restart the magnet recognition procedure (see page 10).

Memorising an optical safety edge transmitter

[1]. Press button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver Prog indicator
light will flash and then go out (this may take a few seconds, the time
required for the transmitter and receiver to communicate with each other).
The transmitter is memorised in the receiver.

CLEARING thE REMotE CoNtRoLs

Clearing a remote control

Executing "Remote control memorisation" procedures on an already memorised remote control clears it.

Clearing all remote controls

Press button on the receiver (for approximately 7 seconds) until the indicator light above it goes out.
Prog
Release button on the receiver when the indicator light goes out; the indicator light flashes slowly.
Prog
All memorised remote controls will be cleared.
Prog
18
Prog
Press and hold down for 7 seconds
1 2 3 4
STOP
x5
1 2 3 4
STOP
1 2 3 4
STOP
4s
1 2 3 4
STOP
Prog Prog
1 2 3 4
Prog
STOP
Safety edge
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
Prog
Copyright © 2012 Somfy SAS. All rights reserved
Prog
Prog
Prog
Prog