Resistive Safety Edge Transmitter (Ese) - SOMFY HOME MOTION ROLLIXO RTS Manual De Instalación

Rollixo RTS
Indicator light status
optical wired
safety edge
Resistive
wired safety
edge
Radio safety
edge
Photoelectric
cells
Radio

Resistive safety edge transmitter (EsE)

Press the button on the back of the transmitter once.
The transmitter indicator light will come on:
If the indicator light flashes:
6 times → the safety edge is faulty (short-circuit).
8 times → the safety edge has not been correctly lengthened (open circuit).
20
Diagnostics
Prog
Optical wired safety edge
failure
Resistive wired safety
edge failure
Radio safety edge failure
Radio interference on the
safety edge transmitter
Magnets missing if the
resistive safety edge
transmitter is installed
End of life of the safety
edge transmitter batteries
Obstacle detection
Cell fault
Bridged cell connector
Obstacle detection
Radio frame received from
a recognised transmitter
Consequences Actions/troubleshooting
Opening ok - Check the type of safety edge connected (optical wired
Closed by pressing safety edge, dipswitch no.4 set to OFF); if the wired safety
and holding down edge is resistive, move dipswitch no.4 to ON.
- Check the safety edge wiring (see page 14).
- Check that no radio safety edge transmitter is memorised in
the receiver. If a radio safety edge transmitter is memorised
in the receiver, clear it (see page 19).
Opening ok - Check the type of safety edge connected (resistive wired
Closed by pressing safety edge, dipswitch no.4 set to ON); if the connected
and holding down safety edge is resistive, move dipswitch no.4 to OFF.
- Check the safety edge wiring (see page 14).
- Check that no radio safety edge transmitter is memorised in
the receiver. If a radio safety edge transmitter is memorised
in the receiver, clear it (see page 19).
Opening ok Request movement again and if the problem persists:
Closed by pressing - See radio safety edge transmitters for diagnostics (see
and holding down pages 20 and 21).
- Repeat the safety edge transmitter memorisation procedure
on the receiver (see page 18).
Opening and If a powerful radio system is present on the site (infrared
stopping ok detector, TV transmitter, etc.) and is transmitting on the same
Closed by pressing frequency, the receiver will wait for the transmission to end to
and holding before controlling the door again.
down: the closing
movement will
automatically
resume when the
radio interference
disappears.
Opening ok Check for the presence of magnets and install them if required
Closed by pressing (see pages 9 and 10).
and holding down
Opening ok Safety edge transmitter low battery indication.
Closed by pressing If the fault persists, replace the safety edge transmitter
and holding down batteries.
Remove the Check that no obstacle is causing the safety edge to detect.
obstacle by
automatic partial
opening
Opening ok If no cells are installed, check that the connector (terminals 18
Closed by pressing and 19) is bridged.
and holding down If cells are installed:
- Check that no obstacle is cutting across the cell beam
- Check the position of dipswitch no.2 in accordance with the
type of cell (see page 12).
- Check the cell wiring (see page 13).
Opening ok If no cells are installed and cell connectors are bridged
Closed by pressing (terminals 18 and 19), check that dipswitch no.1 is set to OFF.
and holding down
Remove the Check that no obstacle is cutting across the cell beam
obstacle by full
automatic opening
Copyright © 2012 Somfy SAS. All rights reserved