Electrical Connections; Data Plate - SCHOLTES FP T6.1 Manual De Instrucciones

Electrical connections

! Ovens equipped with a three-pole power supply
cable are designed to operate with alternating
current at the voltage and frequency indicated on
the data plate located on the appliance ( see below ).
Fitting the power supply cable
Connecting the supply cable to the mains
Install a standardised plug corresponding to the
load indicated on the data plate ( see side ).
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum
contact opening of 3 mm installed between the
appliance and the mains, suitable for the load indicated
and complying with current electrical regulations (the
earthing wire must not be interrupted by the circuit-
breaker). The supply cable must not come into contact
with surfaces with temperatures higher than 50°C.
! The installer must ensure that the correct electrical
connection has been made and that it is compliant
with safety regulations.
Before connecting to the power supply, make sure that:
• The appliance is earthed and the plug is
compliant with the law.
1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
( see diagram ).
2. Loosen the cable
clamp screw and
remove it, using a
screwdriver as a lever
(see figure).
3. Remove the wire
contact screws L-N-
, then fasten the wires
under the screw heads,
respecting the colour
code: Blue (N), Brown
(L) and Yellow-Green
Verde ( ).
• The socket can withstand the maximum power of
the appliance, which is indicated on the data plate
( see below ).
• The voltage must be in the range between the
values indicated on the data plate ( see below ).
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only ( see Assistance ).
! The manufacturer declines any liability should
these safety measures not be observed.

DATA PLATE

width 43.5 cm
Dimensions height 32 cm
depth 40 cm
Volume lt. 56
voltage: 220-240V ~ 50Hz
Electrical maximum power absorbed
connections
2800W or 2560-3050W
(see data plate)
Directive 2002/40/EC on the label
of electric ovens.
Standard EN 50304
ENERGY LABEL Energy consumption for Natural
convection - heating mode:
Convection mode.
Declared energy consumption for
Forced convection Class - heating
mode:
This appliance conforms to the following
European Economic Community directives:
- 2006/95/EEC of 12/12/06 (Low Voltage)
and subsequent amendments;
- 2004/108/EEC of 15/12/04 (Electromagnetic
Compatibility) and subsequent amendments;
- 93/68/EEC of 22/07/93 and subsequent
amendments.
- 2002/96/EC and subsequent amendments.
- 1275/2008 stand-by/off mode.
Rotisserie.
15
GB