Automatic Cleaning With The Pyrolysis Function - SCHOLTES FP T6.1 Manual De Instrucciones

D
4. Finally, fit the frames on spacer A.
! Do not place the sliding racks in position 5.
Automatic cleaning with the PYROLYSIS
function
With the PYROLYSIS mode, the internal temperature
of the oven reaches 500°C. The pyrolytic cycle is
activated and burns away food and grime residues.
Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven due to
the spontaneous combustion process. There is no
cause for concern: this process is both normal and
hazard-free.
Before initiating the PYROLYSIS mode:
• Remove large or coarse food residues from inside of
the oven using a damp sponge. Do not use
detergents.
• Remove all accessories.
• Do not place tea towels or pot holders over the oven
handle.
! If the oven is too hot, the pyrolytic cycle may not
start. Wait for the oven to cool down.
! The programme may only be started once the oven
door has been closed.
To activate the PYROLYSIS mode, press the
button; the TIME display will show the default
duration of 1h30 (normal cycle) while the
TEMPERATURE display will indicate "nor"; pressing
the "+" button activates the intensive cycle "int",
which lasts 2h; the "-" button activates the economy
cycle "eco", lasting 1h.
3. Secure the two
frames with the guide
rails using the holes
provided on the oven
walls ( see diagram ).
The holes for the left
frame are situated at
the top, while the holes
for the right frame are
at the bottom.
Safety devices
• The door is locked automatically as soon as the
temperature exceeds a certain value.
• Should a malfunction occur, the heating elements
will switch off.
• Once the oven door has been locked, you cannot
change the duration and end time settings.
! Programming is possible only after selecting the
PYROLYSIS mode.
Programming delayed automatic cleaning
1. Press the button; the
numbers on the TIME display will flash.
2. To set the duration, press buttons "+" and "-";
press and hold to scroll the numbers quicker and
make setting easier.
3. Once the desired end of cooking time is reached,
wait 10 seconds for the selection to be memorized,
or press button again to fix the setting.
4. When the selected time has elapsed, END appears
on the TEMPERATURE display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO)
PYROLYSIS mode level has been selected: default
set time 1 hour. 12:30 is selected as the end time.
The programme will start automatically at 11:30 a.m.
Programming has been set when the
flash. After programming, in the time before the
PYROLYSIS mode starts, the TIME display indicates
the duration and end of the PYROLYSIS mode
alternately.
To cancel a programming procedure press the "STOP"
button.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the
oven has cooled down sufficiently before you can
open the oven door. You will notice some white dust
deposits on the bottom and the sides of your oven;
remove these deposits with a damp sponge once
the oven has cooled down completely. You may on
the other hand prefer to take advantage of the heat
accumulated to start cooking immediately; in this
case the dust can stay where it is: it is completely
harmless and will not affect your food in any way.
button and the
and buttons
23
GB