SOMFY V300 Guía De Instalación Y Uso página 121

V300
5.1.1 Connecting to a Somfy gate motorisation
Note: When the motorisation is solar-powered, the wired controls are deactivated. In this case, you must use the monitor's wireless
control to control your gate motorisation: see "7.1 Adding an RTS device (radio technology Somfy)".
[1]. Disconnect the motorisation from the mains power supply.
[2]. Remove the cover from the control cabinet or from the motor containing the electronics.
[3]. Connect the door station dry contact output (COM and NO) to the motorisation electronics. It is best to consult the gate
motorisation instructions when connecting a key-operated switch.
Connect...
COM
NO
Note: To connect the door station to another gate motorisation model, please consult the installation guide for this motorisation
contact your installer if it is a motorisation installed by a professional installer
5.1.2 Connecting to an electric latch/lock
Connect the door station "+" and "-" terminals to the latch/lock in
accordance with the diagram opposite.
Observe the +/- polarity if indicated in the latch/lock instructions.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
to the START termi-
nals
5
6
Somfy motorisations electronics
to the BUS termi-
nals
3
4
.
to the numbered terminals
3
5 (for complete opening)
or
6 (for pedestrian opening)
800 mA max
EN
or
11