Lenco CR-16 Manual De Usuario página 5

on! If the reception cannot be automatically adjusted after 10
minutes in spite of the alignment of the integrated antenna, the
reception in the respective location is too weak. In this case, set
the time manually or change location.
POWER ON/STANDBY
1. In standby mode, tap the POWER ON-OFF button once to turn
2. Press the POWER ON-OFF button once to return the unit to
CALENDAR AND TIME MANUAL SETTING
SETTING THE CALENDAR AND TIME
When the device is searching for a radio signal, it is not possible
to adjust the time manually.
1. Press the POWER ON-OFF button to switch the device into
2. Press and hold the SNOOZE/SLEEP/DIMMER button. The
3. Press and hold the SNOOZE/SLEEP/DIMMER button for
4. Press and hold the CLK.ADJ. button for about 2 seconds to
5. The year indicator will flash on the LED DISPLAY for up to 30
6. While the display is flashing, repeatedly tap the << or >>
7. Repeat steps #2 to #3 to adjust the month, day, time format,
Notes:
-
Lenco CR-16.indd 5
on the unit.
standby mode.
standby mode.
"RCC ANTENNA TOWER Indicator" symbol starts flashing in
the display.
about 2 seconds. The "RCC ANTENNA TOWER Indicator"
symbol disappears from the display.
enter the calendar/time set mode.
seconds prompting for a new entry.
button to adjust to the correct year. Press and hold the << or
>> button for faster scanning backward or forward. Tap the
CLK.ADJ. button to confirm.
current hour and finally the current minutes in the same way.
The display sequence in calendar/time set mode will be as
follows:
Year → Month → Date → 12/24 Hour Time Format → Real
Time Hour → Real Time Min → Normal Time
16 1 30 4:34