Nap Alarm; Dimmer Control; Projection Function - Lenco CR-16 Manual De Usuario

NAP ALARM

The nap alarm can be used for e.g. a short "nap". The function
only operates in standby.
-
-

DIMMER CONTROL

Tap the DIMMER button to set the brightness of the LED display
to high, medium or low according to your ambient light conditions.
ALTERNATE DISPLAY BETWEEN TIME AND MONTH-DATE
DISPLAY
1. In radio off mode, press and hold the unit BETWEEN DISPLAY
2. The DISPLAY will alternate between the current Time for 10

PROJECTION FUNCTION

Notes:
-
-
-
-
Lenco CR-16.indd 10
Press the unit NAP button to select the time after which the
device will beep. Select from 90 to 10 minutes or OFF (off) in
steps of 10 minutes.
After the selected time has elapsed, an increasingly fast beep
will sound. Use the unit POWER ON-OFF button to turn off the
beep.
CONTENTS button for about 3 seconds until "ON" appears in
the LED DISPLAY.
seconds and month- date for 5 seconds as follows:
TIME Indicator
This appliance is featured with a projection function and can
be used in either clock or radio mode. You can use this
appliance to project time on the ceiling or wall.
Optimal projection distance ranges from ca. 90 to 270cm.
Press PROJECTION ON/OFF button to illuminate the
projection lens. Time is projected on the ceiling or wall.
Use angle/sharpness controller to achieve optimal projection
MONTH Indicator DAY Indicator
16 1 30 4:34