WARNING:
YOUR SAFETY IS IMPORTANT TO YOU AND TO OTHERS,
SO PLEASE READ THESE INSTRUCTIONS BEFORE YOU
OPERATE THIS HEATER.
GENERAL HAZARD WARNING:
FAILURE TO COMPLY WITH THE PRECAUTIONS AND
INSTRUCTIONS PROVIDED WITH THIS HEATER, CAN
RESULT IN DEATH, SERIOUS BODILY INJURY AND
PROPERTY LOSS OR DAMAGE FROM HAZARDS OF
FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON
MONOXIDE POISONING, AND/OR ELECTRICAL SHOCK.
ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW
THE INSTRUCTIONS SHOULD USE OR SERVICE THIS
HEATER.
IF YOU NEED ASSISTANCE OR HEATER INFORMATION
SUCH AS AN INSTRUCTIONS MANUAL, LABELS, ETC.
CONTACT THE MANUFACTURER.
CONTENTS
Section 1 INTRODUCTION.........................................................2
Section 2 PLANNING.................................................................3
Section 3 INSTALLATION & ASSEMBLY.......................................6
Section 4 Engineering Specifications .......................................13
Section 5 VENTING/DUCTING................................................ 14
Section 6 GAS PIPING..............................................................17
Section 7 WIRING....................................................................18
Section 8 OPERATION MAINTENANCE.....................................19
Section 8 TROUBLESHOOTING.................................................21
Section 9 REPLACEMENT PARTS..............................................22
WARRANTY INFORMATION.....................................................28
Enerco | Heatstar ERXL Series Heater
WARNING:
FIRE, BURN, INHALATION, AND EXPLOSION HAZARD.
KEEP SOLID COMBUSTIBLES, SUCH AS BUILDING
MATERIALS, PAPER OR CARDBOARD, A SAFE DISTANCE
AWAY FROM THE HEATER AS RECOMMENDED BY THE
INSTRUCTIONS NEVER USE THE HEATER IN SPACES
WHICH DO OR MAY CONTAIN VOLATILE OR AIRBORNE
COMBUSTIBLES, OR PRODUCTS SUCH AS GASOLINE,
SOLVENTS, PAINT THINNER, DUST PARTICLES OR
UNKNOWN CHEMICALS.
WARNING:
The State of California requires the following warning:
COMBUSTION BY-PRODUCTS PRODUCED WHEN USING
THIS PRODUCT CONTAIN CARBON MONOXIDE, A
CHEMICAL KNOWN TO THE STATE OF CALIFORNIA
TO CAUSE CANCER AND BIRTH DEFECTS (OR OTHER
REPRODUCTIVE HARM).
SECTION 1:Introduction
Heatstar ERXL models are low-cost, field assembled infrared
heaters that are easy to install and require only minimal
maintenance. They are designed to provide years of economical
operation and trouble-free service.
Checking Shipment
Check the shipment against the Bill of Lading for shortages.
Also, check for external damage to cartons. Note any
shortages, and/or external damage to cartons on the Bill of
Lading in the presence of the delivery trucker. The delivery
trucker should acknowledge any shortages or damage by
initializing this "noted" Bill of Lading. Immediately report
any claims for damaged material, or shortages that were not
evident at the time of shipment, to the carrier and your Enerco
Group, Inc Factory Representative.
Installer Responsibility
All heaters and associated gas piping should be installed in
accordance with applicable specifications and this installation
made only by firms (or individuals) well qualified in this type of
work. Consult local building inspectors, Fire Marshals or your
local Enerco Group, Inc Factory Representative for guidance.
Heatstar ERXL heaters are installed on the basis of information
given in a layout drawing, which together with the cited codes
and regulations, comprise the basic information needed to
complete the installation. The installer must furnish all needed
material that is not furnished as standard equipment, and it
is his responsibility to see that such materials, as well as the
installation methods he uses result in a job that is workmanlike
and in compliance with all applicable codes.
Enerco Group, Inc Factory Representatives have had training
and experience in the application of this equipment and can
be called on for suggestions about installation which can save
material and money.
2
Operating Instructions and Owner's Manual