Safety Instructions And Warnings; General Safety Instructions; Use According To The Intended Purpose - Kübler CODIX 54U Instrucciones De Puesta En Servicio

Operating instructions
Electronic display counter
C C O O D D I I X X 5 5 4 4 U U

1.1 Safety instructions and warnings

Only use this display
– in a way according to its intended
purpose
!
– if its technical condition is perfect
– adhering to the operating
instructions and the general
safety instructions.

1.2 General safety instructions

1. Before carrying out any installation or maintenance
work, make sure that the power supply of the digital
display is switched off.
2. Only use this digital display in a way according to its
intended purpose:
f its technical condition is perfect.
Adhering to the operating instructions and the gen-
eral safety instructions.
3. Adhere to country or user specific regulations.
4. The digital display is not intended for use in areas
with risks of explosion and in the branches exclud-
ed by the standard EN 61010 Part 1.
5. The digital display shall only operated if it has been
correctly mounted in a panel, in accordance with
the chapter "Main technical features".
1.3 Use according to the intended
purpose
The digital display may be used only as a panel-
mounted device. Applications of this product may
be found in industrial processes and controls, in
manufacturing lines for the metal, wood, plastics,
paper, glass, textile and other processing indus-
tries.
Over-voltages at the terminals of the digital dis-
play must be kept within the limits in Category II
If the digital display is used to monitor machines
or processes in which, in case of a failure of the
device or an error made by the operator, there
might be risks of damaging the machine or caus-
ing accidents to the operators, it is your responsi-
bility to take appropriate safety measures.
1.4 Description
CODIX 54U is a multipurpose device. Depending
on the programmed basic function, the device
operates like
• an electronic totaliser and frequency meter
(see page 2)
• an electronic display counter with
2 totalising ranges (see page 4)
• an electronic totaliser and time meter
(see page 6)
• an electronic time meter with 2 time ranges
(see page 9)
2. Setting of the operating parameters
a. Press both front side keys keys and switch on
the supply voltage or, if the supply voltage is
already on, press both keys simultaneously
during 5 s.
b. The display shows
c. After releasing the keys, the display shows
c1.Hold the left key pressed and press the right
key to leave the programming operation.
c2. Press the right key to switch to
d. Hold the left key pressed and press the right
key to switch to the first parameter.
.
13