WAGNER FLEXIO 575 El Manual Del Propietario página 10

Proper Spraying Technique
The room you are spraying must be
properly masked in order to prevent
STOP
overspray from covering woodwork,
oors or furnishings. Make sure you
have properly masked the room per the
instructions on the enclosed "Taping
Guide".
Spray Poster
Surface Preparation
Spray Area Preparation
How to Spray Properly
It is important to keep your arm moving
whenever the gun is being triggered. If
STOP
you pause or linger in one spot too long,
too much material will be sprayed to the
surface.
Partially pulling the trigger will start
the turbine, but no material will spray
STOP
until the trigger is pulled fully. It is
recommended that the trigger rst be
pulled partially in order to start the
turbine before a spray pass is made.
English
10
Even coat throughout
Keep stroke smooth and at an even speed
Light coat Heavy coat
Do not ex wrist while spraying.
During a project, periodically wipe the
nozzle tip with a cloth to remove any
STOP
dried paint.
Note:
6 to 8 inches
Correct
Light coat
Incorrect