Philips SmartSleep Instrucciones De Uso página 16

18
English
Pause mode
Stopping a sleep session
In case you need to get up during the night
(e.g. going to the toilet), the sensor will pause
automatically until you are in a sleeping
position again. The vibrations will start after 5
minutes to give you some time to fall asleep
again.
Note: If you wake up during the night and want
to check if the sensor is still active, press the
activation button briefly. The display lights up
and shows '- -' to indicate that the sensor is
still active. The display will fade out
automatically.
Note: A sleep session can last up to 12 hours,
after which the sensor automatically stops the
sleep session and switches off.
Note: If a sleep session has been stopped and
started again within 2 hours, both sessions are
counted as 1 full sleep session.
You need to manually stop the sleep session
when you wake up and get out of bed.
Press and hold the button for two seconds to
stop the sleep session. If you do not stop the
sleep session, the sensor keeps vibrating when
the Snoring Relief Band is taken off and the
sensor is placed on a horizontal surface.