Philips SmartSleep Instrucciones De Uso página 25

Problem
The sensor
data shown on
the display is
not correct.
Possible cause
The battery was
almost empty
when you started
the sleep session.
If the battery runs
out during a sleep
session, the sensor
switches off and
stops collecting
data. Therefore not
all data of the
sleep session has
been stored.
Within two hours of
stopping a sleep
session, you
started another
sleep session.
The sleep session
lasted more than 12
hours.
English
Solution
Make sure that the
battery is fully charged
before you start a sleep
session to prevent the
battery from running out
during a sleep session.
If you start another sleep
session within two hours
after switching off the
previous session, the
sensor will register these
two sessions as one
single session.
The sleep session was
not stopped properly or
exceeded the maximum
of 12 hours. The session
is stopped automatically
after 12 hours.
27