Setting Up The Clamping Position En; Setting Up The Compressed-Air Motor En - Abicor Binzel BRS-LC Guia De Instalacion

6 Putting into operation
6.5 Setting up the clamping position
1
Fig. 7
 See also Fig. 4 Putting into operation on page EN-10
1 Move the torch with the gas nozzle (1) vertically to the tool axis (milling tool axis) over the BRS-LC (3)
P1 Fig. 4).
2 Approach the clamping position P2 (Fig. 4). Make sure that the cylindrical part of the gas nozzle (1) lies
evenly against the prism (2).
6.6 Setting up the compressed-air motor
1
2
Fig. 8
 See also Fig. 4 Putting into operation on page EN-10
1 Loosen the compressed-air motor from the guide block (4) by removing the screws (3).
2 Pull back the compressed-air motor (5) in its fastener.
3 Place the required distance sleeve (7) on the milling tool (6).
4 Move the torch with the gas nozzle (2) to the clamping position (P2).
5 Keep the guide block (4) in the lower position (stroke down).
6 Place the compressed-air motor (5) against the gas nozzle (2) with the distance sleeve placed
on top (7).
EN - 12
2
Gas nozzle
Setting up the clamping position
1
7
6
5
Clamping device 3 Screws
Gas nozzle 4 Guide block
Setting up the compressed-air motor
1 2
3
Prism
2
3
4
5 Compressed-air motor
6 milling tool
BRS-LC
3
Maintenance station BRS-LC
7 Distance sleeve