Abicor Binzel BRS-LC Guia De Instalacion página 29

BRS-LC
11 Dismounting
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect the mains plug.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-13
12 Disposal
For the BRS-LC to be properly disposed of, it first must be dismounted. For disposal, observe the local
regulations, laws, provisions, standards and guidelines.
 11 Dismounting on page EN-15
12.1 Materials
This product consists for the most part of plastics, steel and non-ferrous metals. Steel and non-ferrous metals
can be molten in steel and iron works and are thus almost infinitely recyclable. The plastic materials used
are marked in preparation for sorting and separation of the materials for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter sewage systems. These materials
must be stored, transported and disposed of in suitable containers. Observe the relevant local regulations
and disposal instructions of the safety data sheets specified by the manufacturer of the consumables.
Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the
manufacturer of the consumables.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always
selected with regard to their possible recycling ability.
DANGER
11 Dismounting
EN - 15