Bradley 400 Serie Manual Del Usuario página 11

Installation
6a Pilasters and Panels with Stainless Steel Continuous Brackets (Optional)
Pilasters located at walls should be mounted first. Start at one end and install a panel, then a pilaster. Continue alternating until
installation is complete. When installing in an alcove or in-corner, use an alcove bracket to secure the pilaster to the panel.
Check to make sure the pilasters are plumb and level to each other. The pilaster height can be adjusted with the
leveling bolt that was placed at the bottom of the pilaster (see page 5 for attaching leveling bolt).
Pilasters at Wall
When installing pilasters at walls, the gaps range
from 1/2" to 1-1/4" (13mm to 32mm). Refer to your
submittal drawing for your gap sizes.
Slide the shoe onto the bottom of the pilaster and
use a piece of tape to keep the shoe positioned
A
above the mounting hardware . Make sure the shoe
mounting hole is facing inside the stall and that the
hole is towards the top .
Position the pilaster so the mounting bracket(s)
sits on the inside of the floor "L" bracket(s) while at
B
the same time placing the pilaster within the wall
bracket . Secure the pilaster mounting bracket(s) to
the floor "L" bracket(s) using the #14 x 5/8" screw(s)
provided .
Using the bracket as a template, drill Ø3/16" holes
C
through the pilaster at each pilaster bracket hole .
Secure the pilaster to the bracket using the
#14 x 5/8" stainless screws provided .
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007
Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Pilasters with Panels
Refer to your submittal drawing and leave the appropriate
gaps. Standard gap is 1" (25mm) between the panel and
wall and 1/2" (13mm) between the panel and pilaster.
A
Place the panel on the spacer and insert the panel into the
wall bracket .
Slide the shoe onto the bottom of the pilaster and use a piece
B
of tape to keep the shoe positioned above the mounting
hardware . Make sure the shoe mounting hole is facing inside
the stall and that the hole is towards the top .
Position the pilaster so the mounting bracket(s) sits on the
inside of the floor "L" bracket(s) while at the same time placing
C
the bracket around the panel . Secure the pilaster mounting
bracket(s) to the floor "L" bracket(s) using the #14 x 5/8"
screw(s) provided .
Using the bracket as a template, drill Ø3/16" holes through
D
the panel at each panel bracket hole . Secure the panel to the
bracket using the #14 x 5/8" stainless screws provided .
3/21/2018
Spacer 12" (305mm)
11