Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
9
Wraparound Gravity Hinges (Standard)
Before installing the hinges, make sure the door openings are the appropriate size, all pilasters are plumb,
secured to the floor and that the headrail is installed.
Refer to your submittal drawings to determine each specific door swing for your application. The door swing is
determined by facing the compartment from the outside. The image below can help determine the door swing type.
Measure down from the top of the pilaster and
A
place a mark at dimensions "A" and "B" for the
respective pilaster type (see table below) . This
mark represents the upper hole location of the top
and bottom hinge .
Floor Mounted Overhead Braced
For 58" wall hung pilaster, establishing dimensions "A" and "B" as shown in the table will
result in the top of the door being flush with the top of the pilaster when the desired cam
setting on the door is set to 0°.
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007
Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Right-hand
Left-hand
inswing
inswing
(RHI)
(LHI)
"A"
"B"
Right-hand
Left-hand
outswing
outswing
(RHO)
(LHO)
B
Using the hinge as a template, drill Ø1/4" holes
through the pilaster .
Wall Hung
69-9/16" (1767mm)
"A"
"B"
3/21/2018
Wall Hung
58" (1473mm)
"A"
"B"
Dim . "A"
Dim . "B"
Floor
Mounted
13-1/2"
67-5/8"
Overhead
(343mm)
(1718mm)
Braced
Wall Hung
13-1/2"
67-5/8"
69-9/16"
(343mm)
(1718mm)
(1767mm)
Wall Hung
2-1/16"
56-3/16"
58"
(52mm)
(1427mm)
(1473mm)
19
Publicidad
Tabla de contenido
