Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
10a Door Hardware for Inswing Doors - Surface
Local codes vary from state to state. Check your local
codes before installing the coat hook and door pulls.
A
Position latch centered top to bottom and with the leading edge 3/8" (10mm) from the door edge .
Using the latch as a template, mark the hole locations and drill Ø1/4" holes through the door .
Secure latch to door with the #10-24 x 3/4" barrel nuts and #10-24 x 3/4" shoulder screws provided .
1/2"
(13mm)
With the door in the closed position, position the strike/keeper on the pilaster and align the top so it
B
is 1/2" (13mm) above the bottom of the latch slide bar . Using the strike/keeper as a template, mark
the hole locations and drill Ø1/4" holes through the pilaster . Secure the strike/keeper to the pilaster
with the #10-24 x 3/4" barrel nuts and #10-24 x 1" shoulder screws provided .
For 34" - 36" doors, mark the location for the top hole on the inside face of the door 30-3/4" (781mm) up from the bottom of 58" tall
C
doors (42-3/4" (1086mm) above finished floor) and 5-1/2" (140mm) from the door edge . Drill (2) Ø1/4" holes (spaced 3-1/2" (89mm)
apart) through the door and secure the door pulls to the door with the #10-24 x 2" flat machine screws provided .
3"
(76mm)
3"
(76mm)
24
3/8"
(10mm)
C L
5-1/2"
(140mm)
30-3/4" (781mm)
(Bottom of Door)
42-3/4" (1086mm)
A .F .F
Place the coat hook 3"
(76mm) down from the top
and 3" (76mm) from the latch
side of the door (hook goes
D
on the inside face of the
door) . Using the coat hook
as a template, drill (2) Ø9/64"
pilot holes through inside face
of the door only . Secure the
coat hook with the #10 x 5/8"
screws provided .
3/21/2018
Flat Strike/Keeper
With the door in the closed
E
position, place flat strike/
keeper so the latch slide bar
fits within the top notch .
Using the flat strike/keeper as
a template, drill (2) Ø1/8" pilot
F
holes through one face of the
pilaster only . Secure the flat
strike/keeper with the #10 x 3/4"
flat head screws provided .
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007
Installation
Publicidad
Tabla de contenido
