Bradley 400 Serie Manual Del Usuario página 16

Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
6f Wall-Hung Pilasters (58" or 69-9/16") - Continuous Aluminum Brackets (Optional)
See Step 2b for instructions on mounting the continuous aluminum
brackets to a wall.
See Step 4a for instructions on mounting the continuous
aluminum brackets to a pilaster.
To establish level line, from the highest point in the room, measure 12" (305mm) from the floor. Use a level to transfer
this mark to the pilaster plumb line.
Pilasters shown in two different lengths for visual reference.
Pilasters at Wall
Slide the wall-hung pilaster into the continuous
A
bracket and align with the established level line .
Refer to the submittal drawing and adjust to meet
the specified dimension .
Using the continuous bracket as a template, drill
B
Ø1/4" holes through the pilaster at each bracket
hole . Secure the pilaster to the bracket using the
#10-24 x 3/4" stainless barrel nuts and #10-24 x 1"
stainless shoulder screws provided .
Wall
58" (1473mm)
Pilaster
12"
(305mm)
Floor
16
Specified Dimension
(Standard Gap 1")
69-9/16" (1767mm)
Pilaster
Pilaster
Plumb Line
12"
(305mm)
Floor
3/21/2018
Pilasters at Pilasters
Slide the wall-hung pilaster into the continuous
A
bracket and align with the established level line .
Refer to the submittal drawing and adjust to meet
the specified dimension .
Using the continuous bracket as a template, drill
Ø1/4" holes through the pilaster at each bracket
B
hole . Secure the pilaster to the bracket using the
#10-24 x 3/4" stainless barrel nuts and #10-24 x 1"
stainless shoulder screws provided .
Specified
Dimension
C L
58" (1473mm)
Pilaster
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007
Installation
69-9/16" (1767mm)
Pilaster