Connecting The Gun To The Welding Machine - Lincoln Electric MAGNUM 100SG Manual Del Operacion

A-10
12. Cut off excess wire 1 to 2 inches from gas diffuser.
Install properly-sized contact tip slightly past hand-
tight. Install gas cone and hand-tighten.
FIGURE A.17
13. Reinstall spool cover. 1: tuck cover's tab in place at
arrow and hold with thumb. 2: swing cover closed.
3: finger-tighten locking knob. 4: check for uniform
fit all around cover.
FIGURE A.18
4
1
INSTALLATION
3
2
MAGNUM 100SG SPOOL GUN
CONNECTING THE GUN TO THE
WELDING MACHINE
1. Disconnect input power to the machine.
2. Make sure that the gun locking knob is loosened.
(See Figure 20).
3. Fully insert gun cable connection (welding power
and gas supply) into machine. Note that the master
Key way for P6 connector is located at the arrow.
FIGURE 19
P6
Connector
Key way
4. Check that the cable connector's end is flush with
insulator at A. Tighten gun locking knob (B) onto
cable connector.
FIGURE 20
B
A-10
A